Error code: 0001000C

<- Back

PG phase sensor error

During initial operation at power on or during platen gap fluctuation (change) operation after paper setting, there may be a case where the PG home position can not be detected. In such a case, this message is displayed and the printer stops operating.

Troubles :
Disconnected connector for the PG Phase Sensor.
Disconnected connector for the PG Motor.
Broken wire for the PG Motor.
Defective PG Phase Sensor.
Defective PG Motor.
Damage to wheel linkage of PG drive gears.
Power supply fuse for PG/PO Motor driver is broken on the MAIN Board.

Points to be checked :
1. Check that the PG Phase Sensor and the PG drive gears are free from obstruction by adhesion of foreign matters or soiling.
2. Measure the resistance value of the PG Motor (7.0 10%). If the PG Motor is found in short mode, replace the MAIN BOARD ASSY at the same time.
3. All the harness must be connected properly and free from short circuit or broken wire.
4. There should be no damage to wheel linkage such as between PG Motor pinion gear and PG drive gears.

Remedy :
1. Connect PG Phase Sensor or PG Motor connector correctly.
2. Replace the PG Phase Sensor.
3. Replace the PG Motor Assy.
4. Replace the C593 MAIN Board.